Poulan-pro PP330 Manuel d'utilisateur télécharger pdf (Page 14)

14

INSPECT AND CLEAN UNIT AND

LABELS

S After each use, inspect complete unit for

loose or damaged parts. Clean the unit and

labels using a damp cloth with a mild deter-

gent.

S Wipe of f unit with a clean dry cloth.

CLEAN AIR FILTER

A dirty air filter decreases engine perform-

ance and increases fuel consumption and

harmful emissions. Always clean after every

5 hours of operation.

1. Clean the cover and the area around it to

keep dirt from falling into the carburetor

chamber when the cover is removed.

2. Loosen bolt with a 5/16 inch (8 mm) socket

wrench. Remove air filter cover and air filter .

NOTE: To avoid creating a fire hazard or

producing harmful evaporative emissions, do

not clean filter in gasoline or other flammable

solvent.

3. Wash the filter in soap and water.

4. Allow filter to dry.

5. Replace parts.

Bolt

Air filter cover

Air filter

MUFFLER AND SPARK ARREST-

ING SCREEN

WARNING: The muffler on this prod-

uct contains chemicals known to the State of

California to cause cancer.

As your unit is used, carbon deposits build up

on the muffler and spark arresting screen.

For normal homeowner use, however, the

muffler and spark arresting screen will not re-

quire any service. After 50 hours of use, we

recommend that your muffler be serviced or

replaced by your authorized service dealer.

REPLACE SPARK PLUG

Replace the spar k plug each y ear to ensur e

the engine starts easier and runs better.

Inspec t spark plug every 25 hours of usage.

Clean and/or replace as necessary. Set spark

plug gap at 0.025 inch (0.6 mm). Ignition tim-

ing is fixed and nonadjustable.

NOTE: This spark ignitio n system complies

with the Canadian standard ICES--002.

1. Twist, then pull off spark plug boot.

2. Remove spark plug from cylinder and

discard.

3. Replace with Champion RCJ-6Y spark

plug and tighten securely with a 3/4 inch

(19 mm) socket wrench.

4. Reinstall the spark plug boot.

SERVICE AND ADJUSTMENTS

REPLACING THE LINE

1. Press the tabs on the side of the trimmer

head and remove cover and spool.

Tab

Tab

Cover

Spool

2. Remove any remaining line.

3. Clean dirt and debris from all parts. Re-

place spool if it is worn or damaged.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Commentaires sur ces manuels

Pas de commentaire